PRODUCT DESCRIPTION
The Saniplus toilet has a high level of styling
The Saniplus is a system that is used to install a complete bathroom up to 15 feet below the sewer line, or even up to 150 feet away from a soil stack. The macerating system of the Saniplus can handle up to four fixtures, toilet, hand basin, shower and bathtub. The Saniplus toilet uses only 6 liters (1.6 USG) of water per flush.
The Saniplus is simplicity itself to install; there are just four connections.
- The macerating pump is connected to the spigot of a horizontal outlet toilet.
- The toilet tank is connected to the water supply.
- The macerating pump is connected to the small diameter discharge pipe work.
- The macerating pump is connected to the electrical supply.
The Saniplus macerating system is comprised of a pressure chamber, which starts and stops the unit, and the motor, which drives the stainless steel macerator blades and pump. To learn more about the macerating process please refer to What is a macerator? A normal operating cycle for Saniplus takes about 10–20 seconds depending upon the discharge pipe run configuration; power consumption is therefore minimal.
Use Saniplus for additional fixtures or appliances
In addition to the toilet waste, Saniplus will also discharge gray wastewater from a variety of other sanitary fixtures, such as: a hand basin, a bath, a bidet and a urinal. When adding a bathtub, a base will have to be constructed made out of 2" x 6" on edge (or 2" x 8" is recommended, if you have sufficient headroom). This allows for the installation of a P-trap and some gravity flow towards the pump unit.
Wastewater from other fixtures is discharged into Saniplus via two 2-inch inlets, on either side of the housing. Either one or both inlets can be used as required. The discharge elbow on top of the Saniplus can be turned either to the left or to the right, depending on the discharge installation.
The Saniplus is designed to provide vertical pumping up to 15 feet as well as a horizontal discharge, therefore a simple ball non-return valve is incorporated. This allows you to install a complete bathroom where previously this would have been impossible or where considerable capital equipment and structural work would have been necessary.
| PRODUCT SPECIFICATIONS |
Dimensions:
Including Pump Only
H12" x W21" x D9"
H30cm x W53cm x D23cm |
Motor: Induction Motor
(no carbon brushes or gears), tested over 50,000 cycles. 3600 rpm |
Electrical supply:
110-115V; 60Hz; 15 AMP; usage 4.65 AMP.
Connect to Ground Fault Circuit Interrupter. |
Discharge:
Horizontally to 150 ft (50m)
Pumps vertically to 15 ft (4.6m) |
| Gravity Fall on Horizontal installations: 1/4" per ft |
Discharge Pipe Diameter:
3/4"; 21mm |
Construction Materials: Polypropylene, C.R.P., stainless steel, Neoprene
Max. temp. 104°F; 40°C |
Normal Running Time:
10–20 seconds subject to installation pipe run |
Water per Flush:
1.6 US gal; 6 liters |
Discharge Rate:
Volume 7.35 gal/m; 27 l/m |
Designed to function with:
Toilet, Hand-basin, Shower, Bathtub.
|
CLICK HERE FOR INSTALLATION MANUAL
CLICK HERE FOR TECHNICAL SPECS
|
